Notes On Use - Epson TM-J7200 Technical Reference Manual

8
Close the Front cover.
The Ink LED will now turn off.
When the ink cartridge is installed for the first time, the Power LED flashes and initial
ink charging starts.
Never open any cover on the printer or turn off the printer during ink charging (while the Power
LED is flashing). Doing so during ink charging will consume a large amount of ink, which may
require replacement of the ink cartridge before completion of charging.
The ink cartridge included in the product package is used for initial ink charging. The printer uses
ink to prepare for printing when the ink cartridge is installed for the first time.
It takes at least two minutes to charge ink. The ink charging time varies depending on the condi-
tions.
When ink charging completes, the Power LED changes from flashing to on.
Perform a test print to check if printing is performed properly. (See

Notes on Use

 Be sure to keep the ink cartridge out of the reach of children. Be sure not to swallow any ink.
 Do not disassemble the ink cartridge or attempt to refill or replace the ink. Doing so could cause ink to leak
or damage the printer.
 Be careful when handling the ink cartridge, as any ink that gets on your clothing may cause a permanent
stain.
 Do not press on the supply section of the ink cartridge, as doing so may cause ink to leak.
 Do not touch the ink supply section of an ink cartridge that has been installed then removed, as some ink
might be stuck on it. Also, be careful where you place it.
 Do not touch the plate on the ink cartridge. The ink cartridge may no longer operate properly.
 The ink cartridge holder in the printer which stores the ink cartridge contains a needle for supplying ink to
the printer, which has ink on it. Do not insert your finger or the like, as it will get dirty.
 Do not remove the ink cartridge from the printer except when replacing it.
Chapter 5 Handling
"Test Printing" on page 81.)
5
77