To install the AC Adapter (only for the TM-J7700)
Follow the procedure below to install the AC Adapter.
Perform the following when installing the AC adapter.
Be sure to use a dedicated AC adapter [PS-180 (model: M159E)].
Install the AC adapter so that its label can still be seen after it is attached.
Use a straight plug for the AC inlet side of the power cable. If you do use an L-shaped plug, install
Be sure to thoroughly read and understand the information on the label of the AC adapter (rating,
1
Turn the printer over.
2
Bundle the DC cable of the AC adapter as shown in the illustration.
The dimensions show are approximate and for use only as a rough guide.
3
Set the bundled part of the DC cable into the empty space inside the printer indi-
cated by the circle.
Insert the DC cable next to the two posts on the bottom of the printer to securely
store the adapter.
➁
Posts
the printer near the power outlet and be sure that the plug can be easily disconnected.
Warning/Cautions) before installing it to the printer unit.
300 mm {11.8"}
200 mm {7.9"}
➀
Chapter 2 Setup
2
150 mm {5.9"}
31