Epson TM-J7200 Technical Reference Manual page 55

3
After briefly pressing the Feed button (less than one second) for the number of times
shown in the print result, hold down the button for more than one second to select
the setting items.
The setting selected as the setting item, the current settings and default settings are printed.
Depending on the setting item, you may need to continue selecting the setting item before the set-
tings are printed.
For details on setting items, see
4
Select a setting by briefly pressing the Feed button (less than one second) for the
number of times applicable to the setting, and then hold down the button for more
than one second to confirm your selection.
After saving the settings, the Software setting mode guidance is printed, and the Paper LED flashes.
5
To close Software setting mode, turn off the printer, or select "Exit" to return to Mode
selection guidance, and then select "Exit and Reboot Printer".
 To select 0 as the item number, hold down the Feed button until printing starts.
 If the button is pressed a number of times that is not displayed by the Setup guidance, the
operation is invalid and the same guidance is printed.
"Software Settings" on page
Chapter 3 Advanced Usage
39.
3
55