Siemens SINUMERIK 828D Manual page 78

3.4
78
Important functions for 3- to 5-axis machining
N240 CYCLE61(35,25.8,5,0,0,0,100,103.6,5,20,0.2,2000,31,0,1,0)
N250 T11 D1; T="CUTTER_D16"
N260 M06
N270 S8000 M03
N280 G54 X50 Y51.76 M08; Pre-position on center of pocket
N290 ; Circular pocket roughing and finishing Plane_1
N300 POCKET4(10,0,2,-
15,40,50,51.76,5,0.1,0.1,2000,2000,0,21,80,0,,10,2.5,0,,,10100,111,10)
N310 POCKET4(10,0,2,-
15,40,50,51.76,15,0.1,0.1,1000,1000,0,22,80,0,,5,2.5,0,,,10100,111,10)
N320 T12 D1; T="CUTTER_D10"
N330 M06
N340 S6000 M03 F500
N350 G54 X0 Y0 M08
N360 ; Calculate swiveling Plane_1 with new center point X1, Y1 X=-15 degrees
N370 CYCLE800(4,"TABLE",220000,57,0,0,50,-15,0,0,50,51.76,0,0,,1)
N380 ; Swiveling Plane_1 additive Y=-7 degrees
N390 CYCLE800(4,"TABLE",200001,57,-35,-24,0,0,-7,0,0,0,0,1,,1))
N400 ; Area -7 degrees with milling cutter face grooving so that the drill inserts vertically later
N410 MCALL CYCLE82(10,0,5,-3,,1,0,1,12)
N420 G0 X0 Y0 M8
N430 X0 Y60
N440 MCALL
N450 ; Calculate swiveling Plane_1 with new center point X1, Y1 X=-15 degrees
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling