Siemens SINUMERIK 828D Manual page 108

3.6
108
Important functions for 3- to 5-axis machining
CYLCE832 in older software releases
Because of the continuous further development of CYCLE832, the syntax and also the functional
scope of the cycle differs between the software releases. Therefore, note the new syntax of
CYCLE832 when using older programs. A compatibility mode can be set via a machine data
item. Contact the machine manufacturer if you have any questions on compatibility.
Software release
SINUMERIK up to SW 7.5
SINUMERIK Operate SW 2.6
SINUMERIK Operate
SW 2.7 to SW 4.4
SINUMERIK Operate
SW 4.5
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
NC code
CYCLE832(tolerance, technology)
CYCLE832(0.01,112101)
CYCLE832(tolerance, machining, version ID)
CYCLE832(0.1,3,1)
CYCLE832(tolerance, machining, version ID) and ORISON
can be programmed separately
CYCLE832(0.005,1,1)
ORISON
OTOL=0.05
When using the ORI tolerance, the activation of the orientation
smoothing with ORISON must be explicitly programmed after
the call of CYCLE832.
CYCLE832(tolerance, machining, ORI tolerance) and
ORISON can be separately programmed
CYCLE832(0.005,_ORI_FINISH,0.5)
ORISON
When using the ORI tolerance in the CYCLE832, depending
on the configuration of CUST_832, after calling CYCLE832,
the activation of orientation smoothing must be programmed
with ORISON.