Parameters For Cycle832 - Siemens SINUMERIK 828D Manual

3.6
Important functions for 3- to 5-axis machining

3.6.1 Parameters for CYCLE832

CYCLE832 can be set by the machine operator or, within the context of NC program generation,
by the postprocessor or programmer. Dynamic values and NC commands are adapted to
address specific user requirements and they depend on the settings of the machine data
(machine machine manufacturer).
In CYCLE832, the operator can select between the four different types of machining of the
technology group Dynamic G group 59 and activate their dynamic parameters.
CYCLE832 with Advanced Surface based on the well proven COMPCAD compressor. The new
COMPSURF compressor is used for Top Surface. Top Surface when milling inclined line-by-line
contours.
With innovated lookahead functionality, as well as harmonizing velocity profiles of adjacent paths
and optimized acceleration and jerk behavior, CYCLE832 guarantees extremely good surface
quality with short machining times.
1
3
2
By selecting the machining strategy, the CAM program execution is optimized for the machine.
Depending on the selected machining the blue arrows point in the Velocity, Surface
1 2
quality or Accuracy direction. Using the Default values softkey preassigns the cycle
3
parameters, depending on the selected machining.
103
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling