Siemens SINUMERIK 828D Manual page 104

3.6
Advanced Surface
Machining
Tolerance_tol.
104
Important functions for 3- to 5-axis machining
Parameters for the High Speed Setting cycle
1
2
3
4
Parameterizing CYCLE832
At Machining, select one of the deselection, finishing, semi-finishing and roughing
parameters.
If the Top Surface option is activated, then you can select between the two motion controls.
Advanced Surface is the default setting.
Enter a value in the Axis/contour tolerance field.
For multi-axis programs, as of SW 4.5, you can smooth the orientation characteristic in the
cycle and apply an ORI tolerance.
For Top Surface, smoothing can also be activated via a setting data item. When smoothing,
inhomogeneous areas along the path are smoothed.
CYCLE832 parameters (as of SW 4.7 SP2)
Finishing (_FINISH)
Semi-finishing (_SEMIFIN)
Roughing (_ROUGH)
Deselection (_OFF)
Finishing (_ORI_FINISH)
Semi-finishing (_ORI_SEMIFIN)
Roughing (_ORI_ROUGH)
Chord tolerance, contour tolerance, axis
tolerance
(Chord tolerance must be imported from the CAM
system 1:1)
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
Top Surface
Selection for 3-axis programs with plain
text.
Choosing "Deselection" resets the values to
the default values.
Selection for multi-axis programs with
orientation tolerance in plain text.
Tolerance of the linear axes
1
2
3
5
4