Siemens SINUMERIK 828D Manual page 76

3.4
76
Important functions for 3- to 5-axis machining
Procedure for programming swivel movement and subsequent machining:
Swivel the coordinate system into the plane to be machined.
Program the machining process as usual in the X/Y plane.
Swivel the coordinate system back to its original position.
Basic procedure for using the swivel cycle
Call the Swivel function in the program.
Select the name of the swivel data record
Select "yes" for swivel if you wish to perform a swivel movement. Select "new" as swivel
movement if you wish to perform a new swivel movement, or "additive" if you wish to base the
movement on a previous swivel movement
Specify the reference point before rotation (X0, Y0, Z0)
Select the "axis-by-axis" swivel mode directly or via the projection angle
Enter the angle through which the axis should swivel. In the axis-by-axis mode, you can enter
the angle for each axis
5
Shift the zero point on the swiveled plane
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
.
1
.
2
.
.
6
.
3
.
4
1
2
3
4
5
6