Master E24 User Manual page 75

Notices and warnings： « Not support some electronic
devices.»
1) Without receiving any reply comment of communications protocol, the APP
would continue sending signal and wait for acknowledging. And over 15
seconds the tunelinc would off line, and user needs to reset (Such as: phone,
message,
or any sound disturbance comes in. In 15 seconds the connection
would continue but if over 15 seconds, user needs to reset.).
2) TUNELINC's audio cable connector is 4 pin, and the length
limit is 50cm. After downing APP press lower left icon to
connect.
Press icon to connect.
3) TUNELINC's audio cable be sure to use the factory supplied to achieve high quality
transmission. If using non-original audio cable, not only affect the transmit
performance but also may happened unexpected result and we can not provide
assistance by then.
4) After insert the Tunelinc into audio jack do not rotate. The audio cable can not be
curl to prevent effect inductive action and avoid lead to poor contact of
transmission.
5) As using Tunelinc do not put any device on charge in order to reduce the
interference of the transmission.
6) Do not put the Tunelinc audio cable connector in a humid
environment. Plug in the audio cable and adjust the
volume between 70% to 90%.
Press CONNECT
Connect successful and entering APP.
7) Due to operate iConsole + APP needs to increase the volume, therefore, if the
device display the volume warning message, the user needs to press
confirmation for beneficial APP subsequent operations.
8) If BT and Tunelinc are connecting at the same time then the console
would select BT as the main connector.
NOTE:
Android is available in English、German、 Traditional Chinese、Simplified Chinese.
iOS is available in English、Simplified Chinese.
The users can select their prefer language under those options,
otherwise all others would display in English.
EN