STEP 2
1.
Please remove the allen bolt (B-5) and semicircle washers (B-6) from the main frame (H-
20).
2.
Pull the Tension control with upper cable (B-1) of the front post (B-2) and ensure
the tension knob is at the lightest position (minimum position ).
3.
Connect the tension control with upper cable (B-1) and down tension control (D-
1), Then connect the middle sensor wire (B-4) and down sensor wire (D-2)
Remarks: Do not screw one set of the Allen bolt and semicircle washers
too firm at one time. It is better to fix the four sets firmly at the same
time because it helps you to change angles and to fix easily.
EN