Kia K5 2021 Owner's Manual page 61

Safety features of your vehicle
4. Slowly allow the shoulder portion
of the seat belt to retract and lis-
ten for an audible "clicking" or
"ratcheting" sound. This indicates
that the retractor is in the "auto-
matic locking" mode. If no distinct
sound is heard, repeat steps 3 and
4.
ODL3039080
5. Remove as much slack from the
belt as possible by pushing down
on the CRS while feeding the
shoulder belt back into the
retractor.
6. Push and pull on the CRS to con-
firm that the seat belt is holding it
firmly in place. If it is not, release
the seat belt and repeat steps 2
through 6.
7. Double check that the retractor is
in the "automatic locking" mode
by attempting to pull more of the
seat belt out of the retractor. If
you cannot, the retractor is in the
"automatic locking" mode.
Child Restraint System (CRS)
If your CRS manufacturer instructs
or recommends you to use a tether
anchor with the lap/shoulder belt,
refer to "Securing a child restraint
seat with "Tether Anchor" system (if
equipped)" on page 3-36 for more
information.
NOTICE
When the seat belt is allowed to
retract to its fully stowed position,
the retractor will automatically
switch from the "automatic locking"
mode to the emergency lock mode
for normal adult usage.
WARNING
Auto lock mode
Set the retractor to Automatic Lock
mode when installing any Child
Restraint System. If the retractor is
not in the automatic locking mode,
the child restraint can move when
your vehicle turns or stops sud-
denly. A child can be seriously
injured or killed if the child restraint
is not properly anchored in the car.
To remove the child restraint, press
the release button on the buckle
and then pull the lap/shoulder belt
out of the restraint and allow the
seat belt to retract fully.
3
3 39