Advertisement
Available languages
Available languages
OPERATION
3
PLEASE READ 'GENERAL SAFETY INFORMATION' AT THE BEGINNING BEFORE USE
CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting
the handheld/attachments or removing and emptying the dirt container.
IMPORTANT: The vacuum cleaner is equipped with overheat protection. If for any reason the
vacuum cleaner does overheat the thermostat will automatically turn the vacuum cleaner off.
If this happens, remove the battery. Remove and empty the dirt container also check the vacuum
cleaner for blockages. Allow the vacuum cleaner to cool for approximately 1 hour (if you have
cleaned the filter please wait 24 hours for the filter to fully dry before putting back into the machine).
For best cleaning results, filters require cleaning at least every 3 months and should be replaced
every 12 months depending upon use. If the vacuum cleaner is blocked, remove the battery before
removing the blockage.
Assembling your Blade vacuum cleaner
CAUTION: This vacuum cleaner is not free standing. In between uses or when carrying out any
maintenance always lie flat on the floor in a suitable location so it does not become a trip hazard
or can be stepped on.
Line up the connector on
the reach wand with the
Powered Head. Push the
reach wand down onto
the Powered Head until
it clicks into place.
Push the handheld down
onto the reach wand
until it clicks into place.
The upright slim vacuum
cleaner is not free standing
and in between uses must
always be placed in the
wall bracket or laid flat
on the floor, in a suitable
location, so it does not
become a trip hazard
or can be stepped on.
Advertisement
