Advertisement
Available languages
Available languages
OPERATION
7
NOTE: The vacuum has a constantly rotating brushbar when activated. Never leave the vacuum
in one spot for an extended period of time as this may damage the floor surface. Always turn the
brushbar off when cleaning hard floors. The brushbar should be ON for carpets and OFF for hard
floors. To prevent any damage being sustained test on an inconspicuous area of the flooring.
IMPORTANT: If the brushbar has been obstructed, the motor protection sensor may have been
activated. The brushbar will stop and the light on the Powered Head will illuminate red. To reset,
remove the Powered Head from the reach wand/handheld and clear any obstruction. Wait 1
minute before refitting the Powered Head, switch the vacuum on and press the brushbar on/off
button.
Using the pole vacuum cleaner
Place your foot on the Powered Head and pull
the handle backwards to recline.
When the vacuum is
switched on, the boost
on/off button will also
illuminate, confirming
that the boost mode is
'On'. The vacuum
will always start in
boost mode. Pressing
the boost button will
deactivate/activate the
boost mode.
NOTE: Constant use of the boost mode and brushbar feature will reduce the battery run time.
To switch the brushbar on, press the brushbar on/
off button. The light on the Powered Head and the
brushbar on/off light will illuminate to indicate the
brushbar is on and the brushbar will constantly spin.
To switch the brushbar off press the brushbar button
again. The vacuum will always start with
the brushbar off.
To switch the vacuum on, press the on/off
button located on the back of the handle.
The battery level indicator light on the
handle and battery charging light will
illuminate white.
Advertisement
