Download Print this page

Hoover BLADE TBT3V3B1 User Manual page 6

Cordless 32v

Advertisement

Available languages

Available languages

OPERATION
5
PLEASE READ 'GENERAL SAFETY INFORMATION' BEFORE USE
CAUTION: The battery used in this device may present a risk of fire or chemical burn if mistreated.
Do not disassemble or heat above manufacturer's maximum temperature limit (60°C/140°F) or
incinerate. Use of another battery may present a risk of fire or explosion. Dispose of used battery
promptly. Keep away from children. Do not disassemble and do not dispose of in a fire. Do not
attempt to disassemble the battery or remove any component projecting from the battery terminals.
The battery and charger have no user serviceable parts. Fire or injury may result. Prior to disposal,
protect exposed terminals with heavy insulating tape to prevent shorting. The battery is to be disposed
of safely at your local battery recycling centre.
Do not attempt to recharge non-rechargeable batteries. The battery must be removed from the
appliance before it is scrapped. The appliance must be disconnected from the charger/supply mains
before use and when removing or installing the battery into the machine. In case of battery leakages
avoid any contact with the skin.
Installing and charging the battery
CAUTION: Do not use the vacuum when the machine is plugged in and charging.
NOTE: The initial charge is 4 hours and charging will be required before first use. The vacuum can
be charged as a handheld with the reach wand and tools removed or as an upright attached to the
wall bracket. Failure to fully charge the battery before first use (initial charge 4 hours) may result in
poor battery performance. The machine can remain on the battery charger once fully charged. The
life expectancy of the battery will vary depending on the usage of the vacuum.
To charge the machine
(as a handheld) detach
the reach wand and
tools and place the
handheld on a flat,
stable surface. You
can also charge as an
upright vacuum when
attached to the wall
bracket.
Insert the charger lead
into the charging port
located underneath the
nozzle on the handheld.
Plug the charging plug
into the mains.

Advertisement

loading