Advertisement
Available languages
Available languages
Removing blockages from the handheld and reach wand
Press the handheld
release button and
remove the reach wand.
Check and clear any
dirt and debris from this
connection point.
Removing blockages from the Powered Head
IMPORTANT: If the brushbar has been obstructed, the motor protection sensor may have been
activated. The brushbar will stop and the light on the Powered Head will illuminate red. To reset,
remove the Powered Head from the reach wand/handheld and clear any obstruction. Wait 1 minute
before refitting the Powered Head, switch the vacuum on and press the brushbar on/off button.
Press the Powered
Head/accessory release
clip and pull to remove
the Powered Head from
the reach wand.
To test for a blockage in the reach wand, drop
a small ball of paper into the wand. The paper
will drop through if the wand is clear. Use a
broom handle or similar blunt object to remove
any blockage.
Check the Powered
Head for any blockages
and use a blunt object to
remove the blockage.
MAINTENANCE
Using scissors, remove
any threads or hair from
around the brushbar and
clear any dirt or debris
from the Powered Head.
14
Advertisement
