Introduction; If You Are Installing The System; Important Information; Electrical Shock - Fortinet FortiVoice FVC Series Hardware Manual

Introduction

FortiVoice phone systems meet the technical standards for use in specific countries and for
connection to major telephone service providers in those countries. They are subject to
regulatory certification and compliances.

If you are installing the system

• The system can be configured by anyone with basic computer skills once it's installed.
• While most buildings are wired to accommodate the system, you may need to route cabling.
• You may need to connect the system to network equipment such as a router, switch or hub
with a connection to the Internet, and to configure a firewall, computer and the system for
network use.
If you are installing a single system, anyone with basic computer skills can use the
QuickStart Guide

Important information

Electrical shock

Do not open the enclosure.
Do not expose the system to any liquids; that can pose a risk of electrical shock.

Power and lightning surge protection

Surge protection devices are recommended in areas subject to lightning or power surges.
Please consult your reseller for recommended surge protection devices.
If the system has been supplied with surge protection devices to meet local regulatory
requirements, these devices must be installed as described in their installation instructions.
Do not connect or disconnect any telephone lines during thunderstorms.
Telecommunication equipment connected to the FXS port should be UL Listed, and the
connections shall be made in accordance with Article 800 of the NEC.
Caution: To reduce the risk of fire, use only No. 26 AWG or larger (e.g., 24 AWG) UL listed or
CSA certified telecommunication line cord.

Power adapter and power cord

Use only the power adapter and power cord supplied with your phone system. Check that the
supply voltage matches the rating on the power adapter label. If your supply voltage does not
match the power adapter rating, please consult your reseller.
For safe operation, connect the supplied ground cable to the screw post on the back of the
phone system (GND/ ) and the other end to the screw of the face plate of an outlet.
Introduction
and this guide to perform a full installation and configuration.
Page 1 FortiVoice FVC Hardware Specification Guide
FortiVoice