Crop-Cut Adjustment - Roland VersaCamm VS-640i Service Notes

4-8 CROP-CUT ADJUSTMENT (Referential Time : 10min.)
This adjustment is for calibrating the relative positions of Tool and Crop Mark Sensor. If it is not adjusted, the cut-
ting position based on the detected Crop Marks becomes wrong, and that results in the mis-alignment of the Print
and Cut performed under the auto crop mark detection.
This adjustment is required when Crop Mark Sensor or Tool Carriage is replaced.
Before this adjustment, it is necessary to confi rm that [ENABLE] is selected for [AUTO ENV. MATCH].
Also, Take-up Unit must not be used during this adjustment.
Turn on the Sub Power SW while pressing [
1
[ ] keys to enter the Service Mode.
Set up media on the machine.
Any media can be used for this adjustment.
Perform Bidirectional Adjustment referring to [4-3 HEAD AD-
2
JUSTMENT].
[TEST PRINT 2]
3
Select [CUTTING MENU]>[CROP-CUT ADJ.]>[TEST PRINT
2], and press [ENTER] key.
The test print and cut will be performed.
For this step, use the same media that bidirectional
adjustment is done.
], [ ] and
4-33
+
MENU
MENU
SERVICE MENU
SERVICE MENU
PRINT MENU
[ ] [ ]
PRINT MENU
HEAD ADJUST
[ ] [ ]
HEAD ADJUST
BI-DIR.DEFAULT
[ ]
SERVICE MENU
CUTTING MENU
[ ]
[ ]
CUTTING MENU
CROP-CUT ADJ.
[ ] [ ]
CROP-CUT ADJ.
TEST PRINT2
[ ]