Pinch Roller Replacement - Roland VersaCamm VS-640i Service Notes

3-17 PINCH ROLLER REPLACEMENT

Conical type is used on both left & right Pinch Rollers and fl at
1
type is used for the Middle Pinch Rollers.
The marking is done on the outer side of left and
right Pinch Rollers.
There is no marking on the middle Pinch Rollers.
Remove the E Ring on one side of the Pinch Roller and pull
2
out the Shaft.
Make sure not to lose the washers which are
fi xed at both sides of the Pinch Roller.
Put the new Pinch Roller with washers and insert the Shaft
3
into the Pinch Roller.
Fixing operation becomes easy when you put
the washers to the Pinch Roller with grease.
Fix the E Ring and check that the Pinch Roller rotates
4
smoothly.
Left Pinch Roller
Pinch Roller
Shaft
Washer
3-85
Right Pinch Roller
Marking
E Ring
E Ring