Fill The Wet-Cups; Fill The Fluid Tanks - Graco Reactor E-10 Instructions-Parts List Manual

Fill the Wet-Cups

Keep the felt washers in the pump wet-cups saturated
with ISO pump oil. The lubricant creates a barrier
between the ISO and the atmosphere.
Pump rod and connecting rod move during operation.
Moving parts can cause serious injury such as
pinching or amputation. Keep hands and fingers away
from wet-cup during operation. Shut off Motor Power
before filling wet-cup.
1. Fill the wet-cups through slots in the plate (222).
Alternatively, loosen screws and swing the plate
(222) aside.
222

Fill the Fluid Tanks

1. Mix the filled or separated materials in the pail with a
drill and mixing blade before adding to the tanks.
NOTE: Material left in the tanks overnight may need to
be remixed in the tanks.
2. Lift the hose rack to expose tank A and tank B.
311075ZAB
3. Remove tank A cover and pour ISO into tank A (red
F . 7 Fill Tank A with ISO
IG
4. Replace the cover
NOTE: Desiccant filter is blue when fresh, and turns
pink when saturated. Be sure shipping plugs are
removed from openings on desiccant filter.
5. Remove tank B cover and pour resin into tank B
6. Replace the cover
1
TI6985a
if lid is difficult to assemble to tank.
F . 8 Fill Tank B with Resin
IG
side, with desiccant filter in cover). See F
1
(blue side). See F . 8.
IG
1
Add thin coating of grease lubricant to tank o-ring
Installation
. 7.
IG
.
.
19