Table of Contents
Advertisement
Introduction
The factory system defaults are listed in full below. They can be recalled by pressing
RECALL followed by set defaults or by the remote command * RST. All channels will
receive the same set-up. All channels default to the same settings.
Main Parameters:
Std. wave:
Frequency:
Output:
DC offset:
Zout:
Gate/Trigger Parameters:
Source:
Period:
Slope:
Burst count:
Phase
Modulation Parameters:
Source:
Type:
Sum:
Shop for Fluke products online at:
Factory System Defaults
Sine
10 kHz
+2·0 V p-p; output off
0 V
HiZ
Internal
1 ms
Positive
1
0 deg
Off
VCA
Off
MyFlukeStore
www.
Appendix D
1.888.610.7664
.com
D-1
Advertisement
Table of Contents
