Table of Contents
Advertisement
291, 292, 294
Users Manual
PULTRNWID <nrf1>,<nrf2>
QER?
REFCLK <cpd>
SCMLEVEL <nrf>
SETUPCH <nrf>
SEQCNT <nrf1>,<nrf2>
SEQSEG <nrf>,<cpd>
SEQSTEP <nrf>,<cpd>
SEQWFM <nrf>,<cpd>
SUM <cpd>
SUMRATIO <nrf>
SWPCENTFRQ <nrf>
SWPDIRN <cpd>
SWPMKR <nrf>
SWPSPACING <cpd>
SWPSPAN <nrf>
SWPSTARTFRQ <nrf>
SWPSTOPFRQ <nrf>
SWPSYNC <cpd>
SWPTIME <nrf>
SWPTYPE <cpd>
SYNCOUT <cpd>
SYSCLKFRQ <nrf>
SYSCLKSRC <cpd>
TONEEND <nrf>
17-26
Shop for Fluke products online at:
Set the width of pulse−train pulse number
<nrf1> to <nrf2> sec.
Query and clear query error number register.
Set the REF CLOCK IN/OUT to <IN>,
<OUT>, <MASTER> or <SLAVE>.
Set the level for SCM to <nrf> Volts.
Select channel <nrf>
Set count for sequence segment <nrf1> to
<nrf2>.
Set the status of sequence segment <nrf> to
<ON> or <OFF>.
Set the 'step on' parameter for sequence
segment <nrf> to <COUNT>,
<TRGEDGE> or <TRGLEV>.
Set the 'waveform' parameter for sequence
segment <nrf> to <cpd>.
Set the sum source to <OFF>, <EXT> or
<PREV>.
Set the sum ratio to <nrf>.
Set the sweep centre frequency to <nrf> Hz.
Set the sweep direction to <UP>, <DOWN>,
<DNUP> or <UPDN>.
Set the sweep marker to <nrf> Hz.
Set the sweep spacing to <LIN> or <LOG>.
Set the sweep frequency span to <nrf> Hz.
Set the sweep start frequency to <nrf> Hz.
Set the sweep stop frequency to <nrf> Hz.
Set the sweep sync <ON> or <OFF>.
Set the sweep time to <nrf> sec.
Set the sweep type to <CONT>, <TRIG> or
<THLDRST> .
Set the sync output <ON>, <OFF>, <AUTO>,
<WFMSYNC>, <POSNMKR>, <BSTDONE>,
<SEQSYNC>, <TRIGGER>, <SWPSYNC>
or <PHASLOC>.
Set the frequency of the system clock to
<nrf> Hz.
Set the source of the system clock to <INT>
or <EXT>.
Delete tone frequency number <nrf> thus
defining the end of the list.
MyFlukeStore
www.
1.888.610.7664
.com
Advertisement
Table of Contents
