Table of Contents
Advertisement
Installation
This section describes the installation and setup of the DTP2 T 204 switchers. Topics
include:
•
•
•
•
•
•
•
Installation Overview
To install and set up the DTP2 T 204 switcher:
1.
2.
3.
4.
5.
When the output is configured for DTP mode, remote power is available. When the output
is configured for HDBT mode, remote power is disabled and the switcher and receiver each
require its own 12 VDC power supply.
ATTENTION:
Installation Overview
Rear Panel Features
Wiring the Power Connector
Wiring for RS-232 Control
Wiring the Contact/Tally Connectors
Wiring for Over TP RS-232 and IR Control
LockIt HDMI Lacing Bracket Installation
Turn off all equipment and disconnect it from the power source.
(Optional) Mount the switcher on a rack shelf or furniture (see
page 58).
Connect HDMI input sources to one or more of the DTP2 T 204 input connectors.
NOTE: LockIt cable lacing brackets, one for each HDMI input connector, are
provided with the DTP2 T 204. These brackets can be used to secure the HDMI
cables to the rear panel connectors to reduce stress on the connectors and
prevent signal loss due to loose cable connections. For information on attaching
the LockIt brackets, see
page 16).
Connect a DTP or HDBaseT compatible output device to the DTP/HDBT OUT
connector.
Set the TP mode switch to HDBT (up) or DTP (down).
Position this switch BEFORE connecting the appropriate device to the TP
•
connector. Failure to comply can damage the endpoint.
•
Positionnez le sélecteur AVANT de connecter l'appareil approprié au connecteur
TP. Ne pas respecter cette procédure pourrait endommager le point de connexion.
•
Do not connect these devices to a computer data or telecommunications network.
•
Ne connectez pas cet appareil à un réseau de télécommunications ou de données
informatiques.
LockIt HDMI Lacing Bracket Installation
DTP2 T 204 Switcher • Installation
Mounting
starting on
on
5
Advertisement
Table of Contents
