Input Status Panel; Output Status Panel - Extron electronics DTP2 T 204 User Manual

To obtain an IP address automatically:
1. Select the Use DHCP checkbox (see figure 24,
2. Click the Apply button. The dialog box closes.
To set a static IP address:
1.
Ensure the Use DHCP checkbox is not selected.
2. In the IP Address field (
In the Subnet Mask field, enter the subnet mask if required.
3.
4. In the Default Gateway field, enter the default gateway if required.
5. Click the Apply button. The dialog box closes.
To reset all communication settings to the default values:
Click the Reset to Default button (
DHCP is disabled.
•
The IP address is set to 192.168.254.254.
•
The subnet mask is set to 255.255.0.0.
•
The default gateway is set to 0.0.0.0.
•
To cancel pending changes:
Click the Cancel button. The dialog box closes.

Input Status Panel

The
Input Status
( or
HDMI DVI
The following symbols may appear in the HDCP status column:
Symbol
No Signal

Output Status Panel

The
Output Status
The following symbols may appear in the HDCP status field:
Symbol
No Display
), enter an IP address.
2
3
panel (see figure 23,
) and HDCP status of the selected input.
Definition
The signal is HDCP encrypted.
The signal is not encrypted.
No signal has been detected for the input.
panel ( ) displays the signal type and the HDCP status of the output.
3
Definition
The display is HDCP compliant.
The display is not HDCP compliant.
No display is connected.
, on the previous page).
1
). The following settings are set:
, on the previous page), displays the signal type
2
DTP2 T 204 Switcher • Internal Web Page 53