Front Screed Box Burner Lighting Instructions - Graco ThermoLazer 200 Operation

Shutting Off Torch
1. Fully close torch flame adjusting valve.
ti14605a
2. Close manual shut-off valve on propane tank when
finished melting and heating thermoplastic material.
Front Screed Box Burner
Lighting Instructions
Read Important Safety Information, page 14-16.
1. Make sure screed box burners flame adjusting valve
is turned OFF.
2. Open manual shut-off valve on propane tank
located at front of unit.
3. Light torch (see Torch Lighting Instructions, page
20).
4. Open screed box access door.
3A1319K
ti14128a
ThermoLazer 300 shown
TC
ti14140a
5. Slowly open screed box burners flame adjusting
valve.
ThermoLazer 300 /ProMelt
TC
ThermoLazer 200/200
TC
6. Place torch at end of screed box burners to ignite
and use screed box burners flame adjusting valve to
adjust to desired flame.
If material begins to smoke or become discolored, turn
screed box burners down or off to prevent material
from burning.
7. Visually inspect to make sure flame indicators are
glowing.
Shutting Off Burners
1. Fully close screed box burners flame adjusting
valve.
2. Close manual shut-off valve on propane tank.
Lighting Instructions
ti23072a
ti14142a
NOTICE
21