Table of Contents
Advertisement
Lighting Instructions
Rear Screed Box Burner
Lighting Instructions
(ThermoLazer 300
Read Important Safety Information, page 14-16.
1. Make sure screed box burners flame adjusting valve
is turned OFF.
2. Open manual shut-off valve on propane tank
located at front of unit.
3. Light torch (see Torch Lighting Instructions, page
20).
4. Slowly open screed box burners flame adjusting
valve.
22
/ProMelt)
TC
5. Place torch at end of screed box burners to ignite
and use screed box burners flame adjusting valve to
adjust to desired flame.
If material begins to smoke or become discolored, turn
screed box burners down or off to prevent material
from burning.
6. Visually inspect to make sure flame indicators are
glowing.
Shutting Off Burners
1. Fully close screed box burners flame adjusting
valve.
2. Close manual shut-off valve on propane tank.
ThermoLazer
300
shown
TC
ti16990a
NOTICE
ti14128a
3A1319K
Advertisement
Table of Contents
