Transmitter Connection Status; Table 5-1 Transmitter Connection Status - Honeywell OneWireless XYR 6000 User Manual

5. Operation

5.2. Transmitter connection status

5.2 Transmitter connection status
Displayed Definition
status
NO KEY Transmitter needs a key from the
Provisioning Device and is not transmitting.
NOT JOIN Transmitter has backed off and is in between
discovery attempts.
DISCOVER Transmitter has not made a connection to a
FDAP and is in discovery (searching for a
connection to a FDAP). Transmitter will
automatically enter a power saving mode if it
cannot make a connection and will retry later.
SECURING Transmitter has connected with the network
and is validating its key.
JOINING Transmitter has validated its key and is now
negotiating the parameters of the wireless
connection.
JOINED Transmitter has validated the key and has
made a secure connection with at least two
Multinodes. Transmitter should appear in
OneWireless User Inteface as an
uncommissioned device.
18 OneWireless XYR 6000 ISA100.11a Compliant Pressure Transmitter User's Manual

Table 5-1 Transmitter connection status

What to do
Transmit a key to the transmitter. See page
28.
If Transmitter does not join the network
within five minutes, do the following:

Check that Key is correct for the network
you are trying to join.

Check that FDAP(s) in the local area are
turned on and are already a secure part
of the network.

Check if KeyServer is active.

Check the KeyServer Event Log to see if
the Transmitter is actively trying to join.
Errors in the Event Log show that the
Transmitter is trying to join but that there
are problems. Consult the OneWireless
User Inteface documentation for
troubleshooting errors.
Wait for connection. If Transmitter does not
make a connection within five minutes, see
NOT JOIN in this table.
Wait for connection. If Transmitter does not
make a connection within five minutes, see
NOT JOIN in this table.
Wait for transmitter to move to JOINED
state. If this does not occur within five
minutes, then it may mean that the wireless
network does not have enough resources to
allow the transmitter to join. Consult
OneWireless UI documentation for
troubleshooting.
No action required.
Revision 3
March 2012