Registration Roller [Follower] - Canon imageFORMULA P-208 Service Manual With Parts Catalog

Notes on assembling
Assembling work can be performed easily
by securing the top cover (base) with
screws and installing the follower roller.
When passing the shaft, install the follower
roller so that both sides with the rib shape
of the base part of the follower roller face
outward.
Install the spring so that it matches the
shape of the upper cover.
The flat part of the center of the shaft must
touch the end surface of the spring.
COPYRIGHT © CANON ELECTRONICS INC. 2012
CHAPTER 3 DISASSEMBLY & REASSEMBLY

5. Registration Roller [Follower]

1) Remove the top cover (base) according to
the steps in "Eject Roller [Follower]". Un-
hook two pairs of fitting parts
follower shaft holder at both ends by flex-
ing them using a tool with a thin and flat tip,
pull out the shaft and remove the one-way
clutch
ing)
follower roller (with a coil spring)
Note: Handle the follower roller holder care-
fully because it is likely to be deformed.
When the roller is removed, the springs
on the base and the document pressure
may be detached.
CANON P-208 FIRST EDITION
2 , the follower roller (with a bear-
3 , the document pressure
Figure 3-213
1 of the
4 and
5 .
3-7