Follower Roller - Canon imageFORMULA DR-M160 Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

6. Follower Roller

Note: The parts (roller, shaft, shaft holder)
on the registration side and the eject
side are the same.
1) Remove the upper feed guide plate.
(Page 3-7)
2) While supporting the center of the shaft
, insert a tool into the gap
1
the shaft holder
unhook the inner fitting part. Then
remove the 2 rollers
holder. Once you have removed these,
the coil spring
removed.
Note: In the figure below, the registration
roller side is detached.
Figure 3-209
Notes on assembling
Insert the shaft end unit into the
opposite side, and then insert the shaft
holder into the base.
The end of the coil spring should touch
the central flat side of the axle.
3-8
between
3
and base and
2
, shaft, and shaft
4
inside can also be
5
COPYRIGHT © CANON ELECTRONICS INC. 2011 CANON DR-M160 FIRST EDITION