Table of Contents
Advertisement
Belt Maintenance
Removing and Installing the
Belt Guard
Removing the Belt Guard
1. At the back of the machine, locate the right-cross
channel of the frame (Figure 33 and Figure 34).
Note: The back of the machine is on the side opposite
from the eccentric guard.
3
Figure 33
1. Back of the machine
2. Front of the machine
2. Insert a 32 to 38 mm (1-1/4 to 1-1/2 inch) spacer
between the right-cross channel and the engine plate
(Figure 34).
1
2
G020992
3. Eccentric guard
1
2
3
1. Engine deck
2. Right-cross channel
3. Spacer
Note: The spacer will support the engine when the 2
bolts (3/8 inch) are removed.
3. Remove the bolt (1/4 inch) from the belt guard (Figure
34).
4. Remove the 2 shoulder bolts (3/8 inch) from the belt
guard, and remove the belt guard (Figure 34).
Note: Use a strap wrench to keep the isolator from
rotating when removing the 3/8 inch bolt (Figure 35).
1. Strap wrench
2. Isolator
3. Wrench
24
5
4
6
G020916
Figure 34
4. Shoulder bolt (3/8 inch)
5. Belt guard
6. Bolt (1/4 inch)
4
5
3
2
1
G020917
Figure 35
4. Belt guard
5. Bolt (3/8 inch)
Advertisement
Table of Contents
