Table of Contents
Advertisement
Figure 13
1. Maximum fuel level
4. Install the fuel cap securely (Figure 12).
5. Wipe up any gasoline that may have spilled.
Checking the Engine Oil Level
Service Interval: Before each use or daily
Important: Use 4-cycle motor oil that meets or exceeds
the requirements for API service category SJ or later (or
equivalent). Always check the API service label on the
oil container to be sure it includes the SJ or later (or
equivalent) rating.
Do not overfill the crankcase with oil because the engine
may be damaged.
Running the engine with a low oil level can cause engine
damage. This type of damage is not covered by the
warranty.
Note: SAE 10W-30 is recommended for general use. The
other oil viscosities shown in the chart may be used when the
average temperature in your area is within the indicated range.
Crankcase capacity: 0.58 L (0.61 US qt)
1
G020679
5W - 30 / 10W - 30
0
20
40
-20 -10 0
Note: Toro Premium Engine Oil is available from your
Authorized Toro Dealer.
1. Place the machine on a flat, level surface, and stop the
engine.
2. Allow the engine to cool.
3. Clean around the oil dipstick.
4. Remove the oil cap/dipstick and wipe the end clean
(Figure 15).
1
2
1. Fill port
2. Oil cap/dipstick
5. Slide the dipstick fully into the fill port without
threading it into the port (Figure 15).
6. Remove the dipstick and look at the end. If the engine
oil level is low, slowly pour only enough oil into the fill
port to raise the level to the Full mark on the dipstick
(Figure 15).
7. Replace and secure the dipstick (Figure 15).
12
30
60
80 100 F
10
20 30 40 C
Figure 14
3
4
Figure 15
3. Oil level (upper limit)
4. Oil level (lower limit)
o
o
g013375
G019746
Advertisement
Table of Contents
