Installing And Removing The Screed Boards - Toro VS-400 Operator's Manual

Installing and Removing the
Screed Boards
Note: Use straight 5 cm x 15 to 20 cm (2 inch x 6 to 8 inch)
boards or 2-inch thick contoured material.
Maximum screed board widths:
•
Model 68052—457 cm (15 ft)
•
Model 68053—914 cm (30 ft)
Installing the Screed Boards to the
Machine
1. Place the machine on a level, flat surface.
2. Raise the front of the machine 10 to 12 inches,
and align the forward screed board to the forward
U-channel of the frame (Figure 18).
Note: The front U-channel is located adjacent to the
eccentric cover.
9
1
2
3
1. U-channel (right spreader)
2. Eccentric guard
3. U-channel (frame)
4. U-channel (left spreader)
5. Forward screed board
3. Align the screed board to the U-channel and center the
board the machine (Figure 18).
4. Lightly tighten the L-bolts in the forward U-channel
(Figure 18).
7
8
6
4
5
Figure 18
6. Rear screed board
7. U-channel
8. Wingnut
9. L-bolt
5. Raise the rear of the machine 10 to 12 inches, and
align the rear screed board to the rear U-channel of
the frame (Figure 18).
6. Align the screed board to the U-channel, and center
the board to the machine (Figure 18).
7. Secure the screed board to the machine by tightening
all the L-bolts and wingnuts (Figure 18).
Installing the Spreaders
Spreader Position Table
Screed
board
length
Spreader
position
(from the
end of
the screed
board)
1. Using the Spreader Position Table, locate and mark the
positions of the spreaders on both ends of the screed
board.
2. Align channels of the spreader to the screed boards
5
and seat the spreader onto the boards (Figure 18).
3. Slide the spreader along the boards until the outside
edge of the spreader is aligned with the mark on the
board created in step 1.
4. Secure the spreader to the screed boards with the
L-bolts and wingnuts (Figure 18).
5. Attach the spreader to the other end of the screed
board by repeating steps 2, 3, and 4.
Removing the Spreaders and Screed
Boards
1. Place the machine on a level, flat surface.
2. Loosen the wingnuts and L-bolts that secure the
spreaders to the screed boards, and remove the
spreaders (Figure 18).
G020865
3. Raise the rear of the machine10 to 12 inches, and
remove the rear screed board from the rear U-channel
of the frame (Figure 18).
4. Loosen the wingnuts and L-bolts that secure the rear
screed board to the rear U-channel of the frame, and
remove the screed board (Figure 18).
5. Raise the front of the machine10 to 12 inches, and
remove the forward screed board from the forward
U-channel of the frame (Figure 18).
6. Loosen the wingnuts and L-bolts that secure the
forward screed board to the forward U-channel of the
frame, and remove the screed board (Figure 18).
7. Carefully lower the machine.
14
457 cm 610 cm 762 cm
(15 ft) (20 ft) (25 ft)
61 cm 91 cm 122 cm
(2 ft) (3 ft) (4 ft)
914 cm
(30 ft)
152 cm
(5 ft)