Lubrication; Greasing The Machine - Toro 4045 Operator's Manual

Lubrication

Greasing the Machine

Service Interval: Before each use or daily (Grease
immediately after every washing).
Grease type: General-purpose grease.
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting.
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
Figure 104
Cylinder assembly (view from under machine, near
stabilizer foot)
Figure 105
Track frame (repeat on other side)
Front elevator assembly (top view)
Rear elevator assembly (top view)
Front pipe-loader cam area (6 fittings)
83
Figure 106
Figure 107
Figure 108