Control Panel - Toro 4045 Operator's Manual

Control Panel

1
2
3
4
5
Figure 38
1. Engine-stop button
2. Exit-side lockout—reset
light
3. Exit-side
lockout—drill-enabled
light
4. Receiver-battery-status
light
5. Engine-start button
Exit-side Lockout—Reset Light
This light (Figure 38) illuminates yellow when the exit-side
lockout function is turned off on exit-side-lockout transmitter,
indicating that you may reset the system.
Exit-side Lockout—Drill-enabled Light
This light (Figure 38) illuminates green when the
exit-side-lockout feature has been turned off and reset and
the machine is ready to drill.
Exit-side Lockout—Reset Switch
Press this switch (Figure 38) to enable drilling operation when
the reset light illuminates.
g021834
6. Ground-strike-reset switch
7. Exit-side-lockout—reset
switch
8. Drive/drill switch
9. Lights switch
10. Engine-speed switch
Transmitter-battery-status Light
This light (Figure
the exit-side-lockout transmitter is too low to transmit. Stop
drilling operations and fix the problem with the transmitter
before continuing.
Engine-start Button
6
Press this button
switch on the rear, control panel must be in the On position.
7
Engine-stop Button
Press this button
8
and all drilling operations. You must pull this button out
before you can start the engine again.
9
Ground-strike-reset Switch
Press this switch
10 after a ground strike has occurred and been fixed; refer to
Deploying the Zap-alert System (page
Drive/Drill Switch
Press the top of this switch
setup controls or the bottom to enable drill and pipe-loader
functions.
Lights Switch
Press the top of this switch
lights on or the bottom of this switch to turn them off.
Engine-speed Switch
•
Press and hold the top of this switch to increase the
engine speed.
•
Press and hold the bottom of this switch to decrease the
engine speed.
•
Release the switch to maintain the current engine speed.
36
38) illuminates red when the battery on
(Figure 38) to start the engine. The key
(Figure 38) to immediately stop the engine
(Figure 38) to reset the Zap-Alert system
67).
(Figure 38) to enable the drive and
(Figure 38) to turn the machine