Drill Frame And Stabilizer Controls - Toro 4045 Operator's Manual

Engine Key Switch
The key switch has 3 positions as follows
1
Figure 45
1. Engine-off position
2. Engine-run position
•
Engine-off position—turn the key to this position to stop
the engine. You cannot start the engine from the operator
platform when the key is in this position.
•
Engine-run position—turn the key to this position after
starting the engine. Turning the key to this position
also enables the engine start button from the operator
platform.
•
Engine-start position—turn the key to this position to
start the engine. Release the key to the Run position once
the engine has started.
Fluid-pump Switch
Use this switch to turn on the fluid pump to use the spray gun
when cleaning the machine
Drill-pendant Receptacle
Plug the drill pendant into this receptacle to attach it to the
machine (Figure 44).
Drive-pendant Receptacle
Plug the drive pendant into this receptacle to attach it to the
machine (Figure 44).
(Figure 45):
2
3
G0221 15
3. Engine-start position
(Figure 44).

Drill Frame and Stabilizer Controls

1. Drill-frame tilt lever
2. Left-stabilizer lever
Stabilizer Levers
Use the stabilizer levers to raise and lower the stabilizers.
Note: The Drive/Drill switch on the operator panel must be
switched to the Drive position for this function to work.
Drill-frame Tilt Lever
Use the drill-frame tilt lever to tilt the drill frame to place
the stake-down plate on the ground or to return the frame
to the travel position.
Note: The Drive/Drill switch on the operator panel must be
switched to the Drive position for this function to work.
42
Figure 46
3. Right-stabilizer lever