Stake-Down Levers - Toro 4045 Operator's Manual

Drill-spindle-control Switch
When this switch is connected to the front drill-pendant
receptacle, move it to control the movement of the drill
spindle.
•
Move the switch forward to rotate the drill spindle
backward toward the pipe holder.
•
Move the switch backward to rotate the drill spindle
forward toward the operator.
Pipe-grip-control Switch
When this switch is connected to the front drill-pendant
receptacle, move it to control the pipe grip.
•
Move the switch forward to tighten the grip on the pipe.
•
Move the switch backward to loosen the grip on the pipe.
Pipe-clamp-control Switch
When this switch is connected to the front drill-pendant
receptacle, move it to control the pipe clamp.
•
Move the switch forward to tighten the clamp on the pipe.
•
Move the switch backward to loosen the clamp on the
pipe.
Cam-rotation-control Switch
When this switch is connected to the front drill-pendant
receptacle, move it to control the movement of the cam.
•
Move the switch forward to rotate the cam backward
toward the pipe holder.
•
Move the switch backward to rotate the cam forward
toward the operator.
Pipe-elevator-control Switch
When this switch is connected to the front drill-pendant
receptacle, move it to control the pipe elevator.
•
Move the switch forward to raise the pipe elevator.
•
Move the switch backward to lower the pipe elevator.
Stationary Pipe-clamp-control Switch
When this switch is connected to the front drill-pendant
receptacle, move it to control the stationary-pipe clamp.
•
Move this switch forward to tighten the stationary-pipe
clamp (for lower wrench).
•
Move this switch backward to loosen the stationary-pipe
clamp (for lower wrench).

Stake-down Levers

1
2
1. Left-stake-raise/lower
lever
2. Left-stake-spin lever
Stake-raise/lower Levers
Push down on these levers to lower the stakes into the ground.
Pull up on these levers to raise the stakes out of the ground.
Note: The Drive/Drill switch on the operator panel must be
switched to the Drive position for this function to work.
Stake-spin Levers
Push down on these levers to spin the stakes clockwise. Pull
up on these levers to spin the stakes counterclockwise.
Note: The Drive/Drill switch on the operator panel must be
switched to the Drive position for this function to work.
45
3 4
Figure 49
3. Right-stake-raise/lower
lever
4. Right-stake-spin lever
g021835