Using The Cylinder Lock - Toro 4045 Operator's Manual

Using the Cylinder Lock

WARNING
The thrust frame may lower when it is in the raised
position, causing serious injury or death.
Install the cylinder lock before performing
maintenance that requires the thrust frame to be
raised.
Installing the Cylinder Lock
1. Start the engine.
2. Lower the thrust frame to the fully-lowered position.
3. Stop the engine.
4. Position the cylinder lock over the cylinder rod
102).
5. Secure the cylinder lock with the cotter pin and clevis
pin (Figure 102).
6. Turn the engine to the On position, and raise the thrust
frame until it rests on the cylinder lock.
Figure 102
1. Cotter pin
2. Cylinder lock
3. Lift cylinder rod
(Figure
4. Clevis pin
5. Lift cylinder
Removing and Storing the Cylinder
Lock
1. Start the engine.
2. Lower the thrust frame to the fully lowered position.
3. Stop the engine.
4. Remove the cotter pin and the clevis pin that secure the
cylinder lock (Figure
5. Remove the cylinder lock.
6. Turn the engine to the On position, and raise the thrust
frame.
7. Store the cylinder lock at the rear of the pipe holder
(Figure 103).
1. Location behind the rear of the pipe holder
82
102).
Figure 103