Advertisement
Main
Sub
code
code
66
10
Image memory contents clear
Used to clear all the image data (including confidential receive contents) in the image memory of the FAX
section. The management table is also cleared (initialized) at the same time.
[CA] key
[INTERRUPT] key : Sub code input
[OK] key
[BACK] key
[START] key
[C] key
11
300bps signal send
Used to send the specified signal at the speed of 300bps by setting the signal number. (Signal send is
continued until interruption is instructed by pressing RETURN key.) The signal send level is selected from
0db and soft switch set values. The signal send level is returned to the sot SW set value before execution of
the mode after completion of the mode.
Sim66-11 300bps SIG.
SIGNAL LEVEL
1:MAX
2:SOFT SW.
( 1 - 2 )
After selection with numeric keys
Sim66-11 300bps SIG.
1:NO SIG.
4:00000
2:11111
5:010101
3:11110
6:00001
( 1 - 6 )
Sim66-10 IMAGE CLR
CLEAR IMAGE MEMORY
[OK] key
After pressing
ARE YOU SURE? EXEC
[OK] key,
during execution
: Simulation cancel
window
: Settlement
: Simulation code input window
: Settlement
: Disable
X
[OK] key
Sim66-11 300bps SIG.
NO SIGNAL
After selection
with numeric keys
X
[OK] key
MX-M182 SIMULATIONS 7-54
Contents
Completion
of execution
Sim66-10 IMAGE CLR
(Highlighted
CLEAR IMAGE MEM.
during execution)
EXEC
Completion of execution
(Highlighted during execution)
With prints
Sim66-10 IMAGE CLR
CLEARED IMAGE MEM.
DO POWER OFF
Power source OFF/ON
[CA] key
: Simulation cancel
[INTERRUPT] key : Sub code input window
[C] key
: Input clear
keys
: Page switch
Numeric keys
: Item selection
[OK] key
: Input value settlement and execution
[START] key
: Input value settlement
[BACK] key
: Signal send stop
Sim66-11 300bps SIG.
OUTPUTING SIGNAL
PRESS BACK TO STOP
After pressing [OK] key,
during execution
EXEC
[OK] key
SIM66-11 initial window
Without prints
Sim66-10 IMAGE CLR
CLEARED
[BACK] key
Simulation code input window
EXEC
[BACK] key
Remark
Advertisement
