Configuring Vst Connections - Yamaha Nuage Setup Manual

Configuring VST Connections

Open the VST Connections window, select the Outputs tab, and create a 9.1 Dolby Atmos Out bus.
Please note, Device Port settings should be left "Not Connected" because, if you directly set the
Device ports here, you won't be able to control speaker volume or mute via Control Room, which
may damage your speaker system.
In the Studio tab, add a Dolby Atmos 9.1 monitor bus and assign the output channels to each speaker.
Here, assign the output channels of Dante Accelerator card which are patched to each output channel
of NUAGE I/O.
152