Important Settings At The Hardware Components - Siemens SINAMICS S120 Manual
Safety integrated extended functions, fail-safe drives, controlling the cu320 from a tm54f and f-cpu
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
SINAMICS S120 Fail-Safe Drives
4.3
Important settings at the hardware components
In this function example, the PROFIBUS interfaces of the F-CPU and the
CU320 are only used for programming. The safety-relevant signal ex-
change between the F-CPU and TM54F is only realized through the hard-
wired 24V signals.
SINAMICS Control Unit CU320
•
PROFIBUS address = 3
•
The PROFIBUS address is set at the DIL switch below the blind
cover of the Control Unit.
SIMATIC IM151-7 F-CPU
•
PROFIBUS address = 4
•
When commissioning the system, the programming device must
be configured as the only master connected to the bus.
I DT Safety Integrated
Page 15/43
Entry ID: 28424136
MC-FE-I-005-V11-EN
Advertisement
Table of Contents
