Table of Contents
Advertisement
Figure 47: Selecting the Scopia XT Telepresence Calibration application in the Setup screen
You can either install this application on a laptop to use it later during calibration or install it
on a USB drive to use a different computer during calibration.
6. Select the destination folder and select Next.
7. Select Install.
The calibration application for your Avaya XT Telepresence is installed.
Related links
Configuring the Avaya XT Telepresence
Calibrating your Avaya XT Telepresence
About this task
During this procedure you use the calibration application to calibrate the cameras and monitors of
the Avaya XT Telepresence so that the images are aligned and can be stitched together to create
the full telepresence effect. The calibration application is protected with the password used for the
Avaya Collaboration Control paired with your Avaya XT Telepresence.
This procedure is performed simultaneously on all three XT Codec Units.
The Avaya XT Telepresence saves the position of cameras during this calibration as the default
position of cameras, which is restored when you restart the XT Codec Units in your Avaya XT
Telepresence.
Before you begin
1. Ensure you have a portable computer.
2. Ensure that you have completed all procedures in
Telepresence
3. Ensure you have the password for the Avaya Collaboration Control paired with your Avaya
XT Telepresence. The default password is 1234.
August 2020
on page 36
on page 36 up until this section.
Avaya Video Conferencing XT Telepresence Deployment Guide
Comments on this document? infodev@avaya.com
Calibrating your Avaya XT Telepresence
Configuring the Avaya XT
67
Advertisement
Table of Contents
