Placing The Microphone Pods - Avaya XT Telepresence Deployment Manual

Setting up the Telepresence Room

Placing the Microphone Pods

About this task
The Avaya XT Telepresence comes with two Microphone Pods. The Microphone Pods are
connected in the cascaded mode: the first pod is connected to the second, and the second pod is
connected to the Master XT Codec Unit
Codec Unit on page 27).
Place Microphone Pods carefully to cover the entire room in case of a standard telepresence room
or to cover the first row in a dual-row telepresence room.
If you want to cover the second table row in a dual-row telepresence room, you need to deploy
third-party audio-in accessories described in Avaya Room System XT Series Third-Party
Accessories for version 2.0.
Procedure
1. Place the Microphone Pods on the table in the telepresence room according to these
specific guidelines
• Rotate the Microphone Pods so the cord extends in the direction of the monitors.
• Place the first Microphone Pod in front of the second chair (participant).
• Place the second Microphone Pod in front of the fifth chair (participant).
• Ensure there is a distance of two meters (approximately) between the Microphone Pods.
• Both Microphone Pods should be 10cm from the edge of the table
Microphone Pods on the table
August 2020
(Figure 23: Connecting the Microphone Pods to the XT
(Figure 22: Placing Microphone Pods on the table
on page 27).
Avaya Video Conferencing XT Telepresence Deployment Guide
Comments on this document? infodev@avaya.com
on page 27):
(Figure 22: Placing
26