Husqvarna 545 Mark II Workshop Manual page 42

5. Push the air filter holder and the carburetor slightly
forward to get access to the screws with the Torx
tool. Remove the 2 screws.
6. Lift the electrical wires from the air filter holder.
7. Disconnect the air filter holder from the rubber parts
on the sides.
42 - Repair instructions
8. Remove the air filter holder
9. Remove the suction hose (B) and return hose (A)
from the air purge bulb. Remove the cable connector
(C) from the contact clamp (E).
A
A
B
Note: Make sure that you remember the position of
the return hose and cabling on the air filter holder.
10. Remove the contact clamp (E) from the bracket on
the carburetor and remove the air filter holder.
B
D
C
E
D
722 - 003 - 26.03.2019