Prepare And Do Servicing On The Product; Maintenance Schedule - Husqvarna 545 Mark II Workshop Manual

3 Prepare and do servicing on the product

3.1 Maintenance schedule

Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
Do a check of the throttle trigger and
throttle trigger lockout.
Make sure that there is no damage
on the vibration damping units.
Clean and do a check of the chain
brake.
Do a check of the chain catcher.
Turn the guide bar, do a check of the
lubrication hole and clean the groove
in the guide bar.
Make sure that the guide bar and saw
chain are getting sufficient oil.
Do a check of the saw chain.
Sharpen the saw chain and do a
check of its tension.
Do a check of the chain drive sprock-
et.
Clean the air intake on the starter.
Make sure that nuts and screws are
tightened.
Do a check of the stop switch.
Make sure that these are no fuel
leaks from the engine, tank or fuel
lines.
Make sure that the saw chain does
not rotate when the engine is at idle
speed.
Make sure that the muffler is correctly
attached, has no damages and that
no parts of the muffler are missing.
6 - Prepare and do servicing on the
product
Weekly maintenance
Clean the cooling system. Make sure
to clean the flywheel wings.
Do a check of the starter, starter rope
and return spring.
Lubricate the needle bearing for the
clutch drum.
Remove burrs from the edges of the
guide bar.
Clean or replace the spark arrestor
mesh on the muffler.
Clean the carburetor area.
Clean or replace the air filter.
Clean between the cylinder fins.
Clean the air channel.
Monthly maintenance
Do a check of the brake band.
Do a check of the clutch centre,
clutch drum and clutch spring.
Clean the spark plug.
Clean the external parts of the carbu-
retor.
Do a check of the fuel filter and the
fuel hose. Replace if necessary.
Do a check of all cables and connec-
tions.
Empty the fuel tank.
Empty the oil tank.
722 - 003 - 26.03.2019