Husqvarna 545 Mark II Workshop Manual page 65

a) Put the guide shaft in a vise.
b) Put the bearing on top of the guide shaft with the
sealing up.
c) Attach the bearing with the sleeve, the screw
and the nut.
2. On the flywheel side:
a) Put the guide shaft in a vise.
b) Put the bearing on top of the guide shaft with the
sealing up.
c) Attach the bearing with the sleeve, the screw
and the nut.
Note: The vise, the screw and the nut are not
necessary when you use a press.
CAUTION: Make sure that dirt and
unwanted particles do not go into the
bearing.
CAUTION: Make sure that you do not put
the force only on the inner ring when you
use the press.
722 - 003 - 26.03.2019
3. Use the rear side of the sleeve and pull the
crankshaft into the crankcase half on the clutch side.
Pull until the crankshaft shoulder touches the main
bearing.
Note: Make sure that you keep the crankshaft in the
correct position.
Repair instructions - 65