Control; Connecting A Computer; Installing The Dedicated Driver; Using Usb Audio - Roland JUPITER-X Reference Manual

Control

Connecting a Computer

MIDI messages can be exchanged with a computer via the
JUPITER-X's USB COMPUTER Port.
MEMO
5
For details on operating requirements and supported operating systems, refer
to the Roland website.

Installing the Dedicated Driver

In order to use the JUPITER-X, you'll need to download the driver from
the following URL and install it on your computer.
For details on installation, refer to the Roland website.
& https://www.roland.com/support/
USB driver settings
Here's how to specify the USB driver that's used when connecting
the JUPITER-X to your computer via the USB COMPUTER port.
* Changes to the USB driver setting take effect when the unit restarts.
1 .
Press the [MENU] button .
The setting screen appears.
2 .
Use the [1] knob to select
the [ENTER] button .
You can also make this selection by using the
buttons instead of the [1]
3 .
Use the [1] knob to select
4 .
Use the [2] knob to specify
Parameter Value
[1] knob [2] knob
VENDOR
USB Driver
GENERIC
5 .
Save the setting .
&"Saving the System Settings
6 .
Turn the JUPITER-X's power off and on again .
USB cable
"SYSTEM," and then press
PAGE [ ] [ ]
knob.
"USB Driver . "
"VENDOR . "
Explanation
Choose this when using the USB driver
that you downloaded from the Roland
website.
Choose this when using the USB driver
that was provided with your computer.
* Only MIDI can be used.
" (p. 43)
(System Write)
Port names when using the VENDOR driver
Audio input device
Device Name Port Name
IN MIX (mixed output of the JUPITER-X)
IN 1 (output of the JUPITER-X's part 1)
IN 2 (output of the JUPITER-X's part 2)
JUPITER-X IN 3 (output of the JUPITER-X's part 3)
IN 4 (output of the JUPITER-X's part 4)
IN 5 (output of the JUPITER-X's part 5)
IN MIC (output of the signal that is input from the JUPITER-X's MIC IN jack)
Audio output device
Device Name Port Name
OUT (USB audio input to the JUPITER-X)
JUPITER-X
OUT MIC (treated as mic input to the JUPITER-X)
MIDI input/output device
JUPITER-X
MIDI IN
JUPITER-X DAW CTRL
JUPITER-X
MIDI OUT
JUPITER-X DAW CTRL
* DAW CTRL is not used for normal MIDI communication.

Using USB Audio

Using the USB driver allows the unit to exchange audio data with a
computer.
For details on how to make settings for your computer, refer to
"Readme.htm" which is in the driver file that you downloaded from
the Roland support page.
& https://www.roland.com/support/
NOTE
Before using USB audio, be sure to make settings so that the USB audio input/
output is not excessively loud.
Adjusting the USB audio input
From your computer or other USB-connected device, adjust the
volume of the audio that is input to the JUPITER-X.
1 .
Press the [MENU] button .
The setting screen appears.
2 .
Use the [1] knob to select
the [ENTER] button .
You can also make this selection by using the
buttons instead of the [1]
3 .
Use the [1] knob to select
4 .
Use the [2] knob to adjust the volume .
5 .
To save the setting, perform the system write
operation .
&"Saving the System Settings
"SYSTEM," and then press
PAGE [ ] [ ]
knob.
"USB In Lev . "
" (p. 43)
(System Write)
39