[ 44 ]
A D D I T I O N A L I N F O R M A T I O N
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code, deregister the code, then
register a different code.
De-register the Security Code
1) Remove the handset from the base. In the standby mode, press and hold
(xfer/del for TXC400) and
DEL/TRANS
"
" appears.
2) Press
to select "
UP
and "
• If you have not pressed any key for 30 seconds while in the de-registering operation, the
phone returns to the standby mode.
• While in de-registering operation, if you receive an incoming call, page, or transferring call, or
charge the handset, or press
until you hear a confirmation tone.
END
", then
. You will hear a confirmation tone,
SELECT/CH
" appears.
or
, the operation is canceled.
TALK/FLASH
END