Install Barrel - Graco PRO Xs Instructions - Parts Manual

Install Barrel

1. Be sure the gasket (11) and grounding spring (14)
are in place. Make sure the air holes are aligned
properly. Replace if damaged. See F
2. Place the barrel (9) over the power supply (12) and
onto the gun body (15).
3. Tighten the three screws (10, 32) oppositely and
evenly (about a half turn past snug).
NOTICE
Do not over-tighten the screws (10, 32).
F . 31. Install Barrel
IG
313227E
. 31.
IG
12
11
10
9
19 (Ref)
4. Assemble the fluid tube (19) into the fluid fitting (23).
Ensure that the ferrules (21, 22) are in place.
Tighten the nut (20).
5. Install and adjust the actuator arm (29) and jam nut
(28). See page 35.
6. Install the gun shroud (48) and air cap (3), page 30.
7. Install the charging probe (2), see page 9.
8. Test gun resistance, page 22.
9. Install the gun onto the manifold and bracket. See
page 29.
15
20
19
14
29
28
32
23
Gun Repair
TI13439a
37