Remove The Gun From The Manifold; Install The Gun On The Manifold - Graco PRO Xs Instructions - Parts Manual

Remove the Gun from the
Manifold
1. Loosen but do not remove the bottom gun screw
(31) until the gun sits loosely in the mounting
bracket slot (A). See F
NOTICE
The piston return spring (105) is compressed
between the manifold and the gun body when they
are assembled. To avoid sudden movement of the
gun body, loosen the bottom gun screw (31) before
loosening the three manifold screws (106). This
allows the gun to move forward gradually as the
manifold screws are loosened. Hold the gun firmly in
hand while loosening the manifold screws.
2. Holding the gun firmly in hand, loosen the three
screws (106) from the back of the manifold.
3. Remove the gun from the manifold and take it to the
service area.
F . 21. Remove Gun from Manifold
IG
313227E
. 21.
IG
106
112
105
A 31 102
TI13433a

Install the Gun on the Manifold

1. Make sure the gasket (112) and spring (105) are in
place on the manifold. See F
for damage and replace them as needed.
2. Secure the gun to the manifold by tightening the
three screws (106).
3. Secure the gun to the mounting bracket (102) by
tightening the bottom screw (31).
Gun Repair
. 21. Inspect the parts
IG
29