Remove Barrel - Graco PRO Xs Instructions - Parts Manual

Gun Repair

Remove Barrel

1. Prepare gun for repair, page 28.
2. Remove the charging probe (2), see page 9.
3. Remove the air cap, page 30. Remove the gun
shroud (48).
4. Carefully loosen the fluid fitting nut (20). Pull the
tube (19) out of the fitting (23). Make sure both fer-
rules (21, 22) and the nut stay with the tube.
5. Remove the jam nut (28) and actuator arm (29). See
page 34.
6. Loosen the three screws (10, 32). See F
NOTICE
To avoid damaging the power supply (12), pull the
gun barrel (9) straight away from the gun body
(15). If necessary, gently move the gun barrel from
side to side to free it from the gun body.
7. Hold the gun body (15) with one hand and pull the
barrel (9) straight off the body. See F
F . 30. Disconnect Fluid Tube
IG
36
. 29.
IG
. 29. F . 29. Barrel Removal
IG IG
9
28 29 30
32
15
19 20 23
9
10
15
TI13438a
TI13437a
313227E