Install Tip And Guard On Gun - Graco 257025 Operation

*Call AAA Rent-All at 225-291-1356 for assistance ordering parts*
14. Continue to trigger gun into waste pail until you see
only paint coming out of gun.
15. Release trigger. Engage trigger lock.
ti8908a
16. Transfer prime tube to paint pail and clip prime tube
to suction tube.
NOTE: If the motor stops, pump and hose are primed
with paint. If the motor continues to run, sprayer is not
properly primed. To re-prime repeat step 8.
3A0248E

Install Tip and Guard on Gun

1. Engage trigger lock.
ti8908a
2. Verify tip and guard parts are assembled in order
shown.
retaining nut
guard
tip
Use tip to align seat
in guard
ti12966a
3. Screw tip and guard assembly on gun. Tighten
retaining nut.
ti12961a
Setup
black rubber gasket and
metal seat
ti12969a
Tip must be pushed
all the way into guard
ti1270a
13